Here are some facts that you may not have known about your boiler whether you’re considering a new installation or needing a service.
- Heat is generated by radiant heating or convection heating
Some boilers emit radiant heat. They heat something specific, such as the flooring. In the UK, most boilers use convection heat to heat the air. The act of heating remains the same, regardless of the system used. The water is heated centrally and then circulated through the system. The water is then pumped into pipes, transferring heat to radiators. For Evesham Boilers, go to http://www.combi-man.com/boiler-finance/boiler-finance-evesham/
- Modern boilers are extremely efficient
The boilers of old were criticised for their inefficiency. Modern boilers use between 85-99% of their fuel consumption, which is an enormous improvement. In the past this figure was closer to 50-70 percent.
- Can a boiler really boil water?
It’s surprising to find out that modern boilers don’t actually boil the water within the system. The old boilers used steam to heat the water, which boiled it up to temperatures as high as 190F. Boilers that no longer use steam are more energy efficient and still keep your home warm.
- New boilers can save you money
Upgrade your old boiler to save up to 30% off of current energy costs. The new models are much more energy efficient. The new models are more energy-efficient and do not bring the water up to full boil. You’ll save a lot of money and see the results almost immediately.
- It is important to have the right water pressure
Did you know the water pressure set for your boiler system differs from that of your plumbing system as a whole? For optimal performance, your boiler’s water pressure should be between 12-15 psi. You will not get enough heat if you set the pressure too low. If you raise it, you may damage your system. By adding more water to the system, you can increase pressure and lower it by bleeding the radiators.
- Do water-based systems cause excess moisture?
A boiler can provide dry heat, even though it uses a lot of water. Water cannot escape from the system because it is completely sealed, including radiators and pipes. The components are non-porous, so you won’t see any water vapour escaping either. You won’t see any increase in the humidity of your home.
